LOCTITE® 222, 10 ml
-
Ideal for low-strength threadlocking of adjusting screws, countersunk head screws and set screws
-
Prevents loosening on vibrating assemblies, e.g. pumps, gear boxes or presses
-
Ideal for small thread sizes up to 6.35 mm
-
Permits disassembly with hand tools
-
P1 NSF Reg. No.: 123002
If you’re working with small diameter screws made of low strength metals (e.g., aluminium or brass), try LOCTITE® 222. It is ideal for low-strength threadlocking of adjustment screws, countersunk head screws, and set screws; on collars, pulleys, tool holders and controllers. It works on most metals without primer, including passive substrates such as stainless steel, aluminium and plated surfaces. It also cures through light coatings of corrosion prevention oils without having to clean the parts.
It is recommended to use LOCTITE® SF 7063/7064 to degrease and clean surfaces prior to applying adhesive.
If cure speed is too slow due to passive metals (stainless steel, aluminium and plated metals) or low temperature (below 5°C), use activator LOCTITE® SF 7649 (see cure speed vs activator graph in the TDS).
Apply liquid threadlocker to the engagement area.
Insert bolt and apply threadlocker to the exposed thread. Assemble nut and tighten to the correct/specified torque.
Apply into lower third of blind hole.
Assemble and tighten. If several bolts are being assembled, torque them down to the correct value within the fixture.