LOCTITE® 222, 10 ml
-
Ideal for low-strength threadlocking of adjustment screws, countersunk head screws and set screws
-
Prevents fastener loosening on vibrating assemblies, e.g. pumps, gearboxes, presses
-
Ideal for small thread sizes up to 6.35 mm (1/4")
-
Can be disassembled with ordinary hand tools for easy service and maintenance
-
NSF P1 Reg. No. 123001
If you’re working with small diameter screws made of low-strength metals (e.g., aluminium or brass), try LOCTITE® 222. It is ideal for low-strength threadlocking of adjustment screws, countersunk head screws and set screws on collars, pulleys, tool holders and controllers. It works on most metals without primer, including passive substrates such as stainless steel, aluminium and plated surfaces. It also cures through light coatings of corrosion-prevention oils without having to clean the parts.
It is recommended to use LOCTITE® SF 7063/7064 to degrease and clean surfaces prior to applying adhesive.
If cure speed is too slow due to passive metals (stainless steel, aluminium and plated metals) or low temperature (below 5°C), use activator LOCTITE® SF 7649 (see cure speed vs activator graph in the TDS).
Apply liquid threadlocker to the engagement area.
Insert bolt and apply threadlocker to the exposed thread. Assemble nut and tighten to the correct/specified torque.
Apply into lower third of blind hole.
Assemble and tighten. If several bolts are being assembled, torque them down to the correct value within the fixture.
-
LOCTITE 222 LOW STRENGTH THREADLOCKER known as Loctite 222 10ML AUSDS_471660_EN_AU | application/pdf
-
LOCTITE 222 LOW STRENGTH THREADLOCKER known as 222 Threadlocker 50ML EN/CH/JPSDS_228581_EN_AU | application/pdf
-
LOCTITE 222 LOW STRENGTH THREADLOCKER known as 222 Threadlocker 250ML EN/CH/JPSDS_228582_EN_AU | application/pdf